Thursday, August 25, 2016

How to Build Capacitor Bank Wiring Diagram for Motorcycle

RealAutoTips. - This is one wiring diagram of capacitor bank circuit that will give you reference how to build yourself capacitor bank for your motorcycle easily to stabilize your motorcycle battery voltage from damage.

Capacitor Bank for Motorcycle (Image:Saft7)

In this article beside we will give you wiring diagram of capacitor bank circuit, here we also will give you step by step on how to build this capacitor bank easily for your motorcycle. Special we also will show you one result for testing the capacitor bank for motorcycle Yamaha Vixion.

Wiring Diagram

Capacitor Bank Wiring Diagram for Motorcycle

Component and Material

  1. 4 x 3.300uF / 16 volts
  2. 4 x 4.700uF / 16 volts
  3. 5 x 1.000uF / 16volt
  4. 8 x 4.7uF / 16volt
  5. 1 x 10nF
  6. 1 x LED
  7. 1 x 1K ohm resistor
  8. Switch
  9. Universal PCB
  10. Ring Terminal 2 sets
  11. Cables
  12. Iron Solder
  13. Tin
  14. Wire
  15. Attactor
  16. Pliers
  17. Scissor

How to build?

  1. After you prepare all component and material, firstly you can arrange all component capacitors, resistor and LED to universal PCB
  2. Connect all pin of components according Capacitor Bank circuit above.
  3. Solder all component pin in universal PCB, and you can cut the long pin component after it.
  4. Connect the (+) battery terminal and (-) battery terminal with ring terminal. You can use switch as the alternative switching with connect switch with starter switch of motorcycle.
  5. Insert capacitor bank to the transparent box.
  6. Connect capacitor bank circuit parallel with battery in motorcycle
  7. And the last you can test the performance of capacitor bank for your motorcycle.


The result of Capacitor bank test in Yamaha V-ixion Injection Motorcycle.

Before using Capacitor Bank (Image:Saft7)

After using Capacitor Bank (Image:Saft7)

Thank you for your coming here in site, we hope the article above will help you to know more about your automotive information like tips and trick, auto news, modification, auto repair software, etc. Please comment here when you want to share and other. Thank you.


  1. Very Nice Project To Protect The Battery!

  2. When first used in branch circuit wiring, aluminum wire was not installed any differently than copper.

  3. the glasses are usually uncomfortable and require charging. Either way, if you're interested in 3D, expect to pay a bit more for a monitor that can handle it thin-bezel monitors wide range

  4. They are available in different sizes or can be cut to fit any desired size. For inserting cables, through the slits and cutting these looms, specific tools are also available.electricians in marlton nj


Thank's for your visit in this blog, Please leave the comment in here